Note that the colors may vary - typically black, red or blue. In the fan/light junction box, connect each switched hot to one of the hot wires on the fan/light. Use a wire nut to connect the panel white neutral to the neutral wire going to the fan/light. You may need a bigger box to properly handle 2 switches - that is based on box fill rules, which I conceptually understand but I am not an expert on that.Īttach the black wire (hot) from the panel to either the common hot connection on the switch (some dual switches include a common hot connector, which makes things easier for situations such as this one), or wire nut (pigtail) the black wire with two short black wires and attach each of those to the hot of a switch.Ĭonnect each of the two switched hot wires (typically one black, one red) to the switched hot screw on a switch.
In that case, replace the cable with a /3 cable - black (switched hot 1), read (switched hot 2), white (neutral), ground. But it is quite likely you have a /2 cable - black (switched hot) + white (neutral) + ground in one cable.
If you have individual wires then you just run another wire (make it a different color from the existing wires) through the conduit from the switch to the fan. Assuming that you currently have 2 wires (plus ground) going from switch to fan, you will need to do the following:Īdd a 3rd wire.